Which of the following memory types has 184 pins?
The term SFF refers to which of the following?
A. CPU speed
B. Memory size
C. Motherboard size
D. HDD size
A threaded coaxial connector used to connect to a TV tuner is MOST often referred to as which of the following?
B. RJ-11 connector
C. IEEE 1394 connector
D. RJ-45 connector
http://www.ramelectronics.net/howto-av.aspx (see Television (TV/HDTV) connections)
A dial-up modem uses which of the following types of connectors?
The MAXIMUM transfer rate of eSATA is:
A. 1.54 Mbps.
B. 2.0 Gbps.
C. 3.0 Gbps.
D. 480 Mbps.
A technician installs a new high-end gaming card into a computer but is not seeing any video. Which of the following power connectors did the technician MOST likely forget to install?
A. 4/8-pin 12v
B. 6/8-pin Molex
C. 20-pin main
D. 24-pin main
A PC cannot connect to the network. A network card was purchased without documentation or driver discs. Which of the following is the BEST way to install it into this machine?
A. From the PC, download and install the drivers
B. Run Windows update to install drivers
C. Copy drivers to flash drive and install
D. Purchase the disc online and install
Which of the following requires a MINIMUM of four hard drives?
A. RAID 0
B. RAID 1
C. RAID 5
D. RAID 10
A coworker has reported that someone has engaged in prohibited activity. The supervisor has asked the technician to quarantine the PC until police arrive. Which of the following should the technician do? (Select TWO).
A. Allow the user to continue working
B. Check for viruses
C. Re-image the hard drive
D. Document time/date for later reference
E. Prevent users from accessing the PC
F. Turn off PC
A customer has asked for the ability to operate dual digital monitors. Which of the following is the BEST solution for accomplishing this?
A. Split the onboard video port.
B. Update the video drivers to allow for multiple monitors.
C. Add an adaptor to the onboard VGA port.
D. Install a video card with multiple DVI ports.
A customer has purchased a 1TB internal hard drive. The customer would like to have it installed as a data drive in their existing system. The technician discovers there is no spare power supply connector for the new hard drive. Which of the following would enable the technician to EASILY accomplish the task? (Select TWO).
A. Replace the existing hard drive.
B. Replace the power supply.
C. Remove the floppy disk.
D. Remove the CD-ROM.
E. Split an existing power connection.
Which of the following pin pairs remain with the same wire color for either T568A or T568B?
A. Pair 1 & 8
B. Pair 2 & 7
C. Pair 3 & 6
D. Pair 4 & 5
Which of the following would be included when documenting the MOST recent policy on corporate behavior?
A. Page numbers
B. Author of the document
C. A complete table of contents
D. Last revision dates and version numbers
Which of the following represents a wiring standard for connectors of twisted pair cables?
Which of the following connectors would be found on a coaxial cable? (Select TWO).
Which of the following BIOS features should be enabled to increase security of the physical computer?
A. Chassis Intrusion Detection
B. Advanced Configuration and Power Interface
C. Antivirus Software
D. Temperature Monitoring
Which of the following amounts of memory BEST represents the upper limit of RAM when using a 32-bit architecture?
A. 2 GB
B. 4 GB
C. 6 GB
D. 16 GB
Which of the following would be an example of prohibited content?
A. Third party proxy sites
B. Malicious cookie
C. Detected virus
D. Unwanted pop-up
Which of the following is NOT a best practice when prohibited activity is suspected?
A. Back up the hard drive
B. Turn off the computer
C. Document the incident
D. Identify the content
When installing multiple SCSI drives in a system, which of the following is correct?
A. All drives must have the same SCSI ID.
B. Drives will be automatically assigned an ID by the controller.
C. Drives in the same RAID array must have the same SCSI ID.
D. Each drive must have a different SCSI ID.